More screenshots
Works with the AI Agents you already use
RF Signal Identification with SDR
Receive-only RF signal identification with software-defined radio — characterize unknown transmissions, identify modulation and protocol, and assess replay risk, always within authorized scope.
$5
RF Signal Identification with SDR
Example session with this skill installed
An unknown signal keeps appearing near 433 MHz in our building. Identify it: what is it, what does it carry, and could it control anything here?
- Read your context and instructions
- Compiled the rf signal identification
Gate one first: the building is ours, the frequency is an unlicensed band, and the work is receive-only — scope confirmed in writing before the radio was switched on. Characterization from the waterfall showed short bursts, about 200 kHz wide, repeating at irregular intervals with a sharp on-off pattern — the shape of a remote control, not a data link. Demodulation identified on-off keying with a fixed preamble, and the decoded frames matched the structure of a common garage-door remote: a fixed code, no rolling sequence, repeated identically on every press. The control-risk assessment is the point of the exercise: a fixed code on this band can be replayed by any transmitter in range, so the door opener is the weak point — not the building's Wi-Fi, not anything else on the band. Recommendation: replace the fixed-code remote with a rolling-code unit, and treat the band as untrusted until then. The capture files and the decoded frames are saved with the report, so the finding can be re-checked without re-capturing. A follow-up sweep a week later found the same signal still active, which confirmed the recommendation instead of reopening the question — the replacement remote was ordered the same day.
Connects securely to your tools. The creator never sees your data.
About this skill
An unknown transmission on the waterfall is a question, not a threat — until the evidence says otherwise. This skill uses software-defined radio for receive-only signal identification: characterizing unknown transmissions from the waterfall, identifying modulation and protocol, decoding legal signals like ADS-B, and assessing replay feasibility for authorized defensive work. Two gates frame everything: scope and law first — what you are allowed to receive, and where — and demodulation only after characterization, because guessing the modulation wastes the capture. The output is a signal report: frequency, bandwidth, modulation, protocol if identified, and a control-risk assessment that says what the signal could do, not what you fear it might do.
Find more skills like this on the Claude Skills Marketplace, the Codex Skills Marketplace and the Gemini Skills Marketplace, or browse Claude Skills for Security.
Receive-only: transmitting, jamming, or replaying a captured signal is outside this skill and usually outside the law.
Identification depends on capture quality — a weak or noisy signal may only support a partial identification, and the skill says so.
Legal boundaries differ by country and band; the skill requires checking the local rules for the specific frequency before receiving.
How to use
- 1
Connect your agent to the Agensi MCP
Copy the prompt and paste it into Claude, ChatGPT, Cursor or any agent that supports MCP. It sets up the connection for you. Manual setup
- 2
Sign in to Agensi
Your agent shows a sign-in link. Sign in and click Allow.
- 3
Ask for what you need
Your agent loads this skill and uses it on your task. It always asks before buying a skill.
Reviews
No reviews yet
Be one of the first to try it. Every listed skill goes through the trust checks below.
Security scanned
Checked by our 8-point scan before listing
Fresh listing
Recently published to Agensi
Money-back guarantee
Doesn't do what its page promises? You get your money back.
Trust & safety
Security scan
Security scan passed 3 days ago
Permissions
No special permissions declared or detected